- 4 -
- 5 -
2� Getting started
For the 1st time you use the Blumax Bluetooth GPS-4012 Receiver, please charge
battery until it is full (the LED blinks). Take the power cable and connect it to the
power jack (mini USB type). This will begin to charge the battery. The LED that
represents the battery is the right-most battery icon (shown in below).
Step 1 Charging Your Battery
Please follow the procedure step by step.
• If the LED is red, that means battery power is critically low. Charge immediately.
• If the LED is green, that means battery is charging now.
• If the LED is blinking, that means battery is fully charged.
• When you plug into the mini USB cable to charge your unit, it will take
5~10 seconds then you can see the green LED turning on.
LED,
represents
the battery
status