13
EN
Accessoriy Pack
Pc.
Description
Pc.
Description
1
Allen Key
2
Washer
2
Screw M6*8
1
Remote Controller
2
Screw M6*27
2
Screw M4*28
1
Cord Clip
2
Screw M6*35
INSTALLATION
1. Take the main body (1), the base (7), the base cover (6) and the accessory
pack out of the box.
2. Turn the main body (1) 180° and fasten the connection board (2) to the
main body (1) with screws (3).
3. Then fasten the clamping board (4) to the connection board (2) with
screws (5).
4. Pull the plug and the power cable through the hole in the base cover (6)
and the hole in the base (7) and fasten the cable clamp (8) with screws (9).
5. Then attach the base cover (6) to the main body (1) using washers (10) and
screws (11).
OPERATION
1. Insert the plug into the socket.
2. The LED light starts flashing and indicates that the appliance is in standby
mode. If you press the MODE button, the appliance starts with a low heat
output. Press the MODE button repeatedly to adjust the heat output in
the following order: low > medium > high > low.
3. Press the SWING button on the unit or remote control to start the
oscillation function. Press the button again to end the function.
4. Press the TIMER button on the unit or remote control to set a time of 0-9
hours. 0 means that the timer is off. Each time the button is pressed, the
time increases by 1 hour.
5. When you no longer need the radiant heater, turn it off by pressing the
OFF button on the remote control or on the unit.
