19
EN
ASSEMBLING
1
Insert 4 M6 nuts into the lower side
of the unit base and align the lower
bar with the hole in the unit base.
Then insert 4 M6x30 screws into the
holes of the lower rod and tighten
them. Attach the decorative ring.
2
3
Screw the middle rod to the bottom
rod and then the top rod to the
middle rod. While doing so, guide the
power cord through the hole in the
base of the unit and carefully pull it
up through the rods.
Connect the power cable to the
connection socket on the heating
head and secure the connection with
a plastic fuse. Align the heating head
to the upper rod and screw it to the
upper rod with 2 M10x12 screws.
