12
3.
Open the small box to take out the spare parts: 3 connecting hoses, 1 inflation hose and 1
filtration set (fitted with a filter cartridge). Store the replacement filter cartridge in a clean
place.
4.
crew one end of the inflation hose with nut onto the control box outlet and tightly insert the
other end into the spa tub’s inflation inlet.
5.
Inflate the spa tub by pressing the Bubble button.
When the spa tub is properly inflated, press the Bubble button to stop inflating.
L
Important:
•
Do not overinflate.
•
If you want to inflate the spa tub when it is filled with water, turn on the bubbles for 2-3
minutes by pressing the Bubble button, remove the air pipe connecting the pool and the
control box and then operate according to steps 4-6.
6.
Remove the inflation hose from the spa tub wall and close the valve.
7.
Remove the inflation hose from the air outlet.
8.
Connect the pool and the control box with the three connecting hoses. Make sure you tighten
each nut, otherwise the tub may leak.
9.
Screw the filter cartridge onto the water inlet in the spa tub wall by turning it clockwise.
10. Fill the spa tub using a garden hose, up to the water level indicated on the spa tub wall.
11. Place the cover over the spa tub and lock it in place.
Figur
e 2
Figur
e 3
EN
2021-10-12 OCG BluMill Spa Pool Ibiza Manual V01.indd 12
2021-10-12 OCG BluMill Spa Pool Ibiza Manual V01.indd 12
16-12-2021 10:06
16-12-2021 10:06
