E-20A-H-O / E-20AJ-H-O User Manual V2.1
15 / 36
Eng
lis
h
Adhesive-backed Paper
Base Plate
Fig. 11-10
(2) Point the four holes of the
Base Plate
towards the four reference points on the back of the
main device to properly stick the plate to the device, as shown in Fig. 11-11.
Base Plate
Fig. 11-11
(3) Point the two
Buckles
at the back of the SpO
2
Kit adapter towards the two buckles of the
base plate, and push until the two units click into place. Insert the SpO
2
Kit connector into the
Communications Port
of the main device, as shown in Fig. 11-12.
Buckle Communications Port
Fig. 11-12
11.7.2 Removing the SpO
2
Kit from the Main Device
First disconnect the SpO
2
Kit connector from the
Communications Port
; then press the
Hook
at the top of the SpO
2
Kit adapter, and at the same time, pull the adapter and base plate apart
in opposite horizontal directions, as shown in Fig. 11-13.
Hook
Fig. 11-13
The SpO
2
Kit is intended to be used for continuous, non-invasive functional arterial oxygen
saturation (SpO
2
) and pulse rate monitoring for adults weighting greater than 40 kg.
The SpO
2
Kit is ready to use immediately when you connect it to the main device via the
Summary of Contents for E-20A-H-O
