InH2
®
Heated Humidifier
User Manual V2.7
5/13
English
Water Chamber
1. Turn the
RESmart
®
device off and allow approximately 15 minutes for the
heater plate and water to cool.
2. Disconnect the tubing from the water chamber. Press down on the water
chamber and slide it out of the humidifier platform.
3. Open the silica gel cover of water chamber and discard any remaining water.
Fill a solution of warm water and a mild dishwashing detergent into the
chamber, cover the silica gel cover, rock the chamber a few minutes, and then
outflow the solution. Rinse the chamber several times with clean water and
allow to air dry.
4. Fill the water chamber and close the silica gel cover. Inspect the water
chamber for any leak or damage. Replace the water chamber if any damage is
present.
Humidifier Platform
1. Clean the humidifier platform by wiping with a damp cloth. Allow to air dry.
2. Inspect the humidifier platform for any damage and replace if necessary.
Silicone Tube of Humidifier
Clean the Silicone Tube by wiping with an alcohol cotton stick. Allow to air dry.
Service
The humidifier does not require routine servicing.
If the humidifier malfunctions, contact your home care provider immediately.
Never attempt to open the humidifier’s enclosure. If necessary, contact your
local authorized dealer or BMC Medical Co., Ltd. for technical support and
documents.
