RESmart BPAP 20T/25T/30T User Manual V1.1
9 / 25
Eng
lis
h
4. Device operation
4.1 Starting the Device
Standby
After power on, system status will appear on display screen as below.
Work Mode
P1
P2
06
08
S Mode
Work Mode:
The starting Mode. Default setting is S Mode. It may vary according to your home
care provider’s setup.
P1:
EPAP when device work on Mode S, Default setting is 6 hPa.
P2:
IPAP when device work on Mode S, Default setting is 8 hPa.
4.2 Using the Ramp Button
Pressing the
Ramp Button
will reduce the air pressure when you are
trying to fall asleep.
The air pressure will gradually increase until your prescription pressure is reached. If your
physician prescribed ramp for you, pressing the button will reduce the pressure and then
gradually increase (ramp) the pressure to the therapeutic pressure setting so that you can fall
asleep more comfortably.
Note: The ramp feature is not prescribed for all users.
Press the
Ramp Button
on the top of the RESmart BPAP 20T/25T/30T. You can use the
Ramp Button
as often as you wish during the night.
4.3 Turning the System OFF
Remove the mask and headgear. Press the
Pressure
Start/Stop Button
on the top of
the RESmart BPAP 20T/25T/30T to stop the airflow. Or, if the Auto Off setting has been enabled,
the airflow will automatically turn off.
IMPORTANT!
The
Humidifier Button
is active only when an InH2 Heated Humidifier is connected or
when the RESmart BPAP 20T/25T/30T is in the Setup Menu. Refer to the InH2 Heated
Humidifier’s instructions for additional information.
Helpful Hints
• If the alert tone sounds, press
Pressure
Start/Stop Button
on the top of the RESmart
BPAP 20T/25T/30T to silence the alert tone. Refer to the “Troubleshooting” Section of the
manual for further instructions.
• Make sure that bedding, curtains, or other items are not blocking the filter or vents of the
RESmart BPAP 20T/25T/30T. Air must flow freely around the RESmart BPAP 20T/25T/30T for
the system to work properly.
• If the airflow from the RESmart BPAP 20T/25T/30T feels cold, reposition the circuit tubing so
that it runs under your bed covers to reduce heat loss while you sleep.
• If interruption of the power supply occurs during system working, the audible alert (a beeping
sound) will start and continue. Restoration of the power supply will stop the audible alert.
