LAN-AD16f
1
Start-up procedure
Plug the red frames onto the short sides of the device with the feet looking downward. The LAN-AD16f is
suitable for DIN rail mounting. The optional DIN rail set
ZU-SCHI
can be ordered at bmcm.
The device is supplied via a power supply unit (12V, 10W) available under
ZU-PW10W
Connect the device to a PC or server via network (see chapter 2.2). The LAN-AD16f self-assigns a suitable
link-local address when being connected.
If necessary, further software components to be used with the device can be installed now, as described in
chapter 4.
2
Connections and pin assignment
Figure 1
2.1
Power supply
The power supply of the DAQ system with 9-40V DC is connected at the 3-pin
DIN plug on the back of the device. The power supply unit
ZU-PW10W
(12V,
12W) is optionally available.
2.2
Network
The PC/data acquisition server and the LAN-AD16f communicate via network, which is real-
ized with by a Twisted Pair connection (100Mbit). If directly connecting the LAN-AD16f to
the PC, a crosslink cable must be used. Both cables are available as accessories (
ZUKA10T
or
ZUKA-CL10T
).
If the two LEDs in the LAN connector are flashing, data are transmitted.
Firewall software installed on the PC might interfere with the operation of the LAN-AD16f. In this
case, please contact your network administrator.
Page 2
