LAN-AD16f
2.3
Analog channels
The 37-pin D-Sub female connector at the back of the device is
designed for the connection of the analog inputs and outputs. Input
range (
±
10V,
±
5V,
±
2V,
±
1V) and output range (
±
10V) are set via
software (e.g. in
NextView
®
4
).
The pin assignment of the 37-pin D-Sub female is as follows:
D-Sub 37 LAN-AD16f D-Sub 37
LAN-AD16f
1 AIn
1
11 AIn
11
2 AIn
2
12 AIn
12
3 AIn
3
13 AIn
13
4 AIn
4
14 AIn
14
5 AIn
5
15 AIn
15
6 AIn
6
16 AIn
16
7 AIn
7
17 n.
c.
8 AIn
8
18 AOut
1
9 AIn
9
19 AOut
2
10 AIn
10
20..37 AGND
The max. potentials to ground must not exceed
±
12V. Any channel overload may influence measure-
ments of other channels and may lead to wrong values.
The internal connection of the 16 analog inputs is provided via
a 40-way pin connector (see figure on the right) on the
LAN-AD16f board, which, for example, can be used to con-
nect current shunts (
ZU-CS250R
available as accessory).
The pin assignment of the 40-way pin connector is listed in the
following table:
Pin
LAN-AD16f
Pin
LAN-AD16f
1 AIn
1
17
AIn 9
3 AIn
2
19 AIn
10
5 AIn
3
21 AIn
11
7 AIn
4
23 AIn
12
9 AIn
5
25 AIn
13
11 AIn
6
27 AIn
14
13 AIn
7
29 AIn
15
15 AIn
8
31 AIn
16
2, 4, .., 30, 32
AGND
33, 34, .., 39, 40
n. c.
Page 3
