3
InStallIng the coMPonentS
Camera module
CAUTION: Make sure the drone is off before connecting the camera.
1. Insert the microSD card into the camera module.
2. Insert the camera module into the front of the drone.
Battery
1. Insert the battery into the back of the drone.
Obstacle sensor
1. Insert the sensor into the grooves on the underside of the drone.
2. Slide the module into the grooves.
Motor
Mounting
1. Insert the motor into the opening.
2. Plug the motor wire into the socket.
3. Replace the landing leg and tighten
the screw (clockwise).
Removing
1. Loosen the screw (counter-clockwise)
and remove the landing leg.
2. Disconnect the motor wire from the
socket.
3. Pull the motor out.
Propeller
1. Attach the propeller to the shaft.
2. Tighten the screw (clockwise).
CAUTION: For proper functioning, use the correct propeller for the correct motor. Each pro-
peller is marked with a letter to indicate which motor it belongs to.
Propeller guard
Snap the guard on the arm and tighten the screw.
Removing the guard
Attaching the guard
CAUTION: If the drone crashes, check that the propellers and guards are not damaged or
destroyed. If they are, they need to be replaced before the next flight.
CAUTION: If you do not want to use the guards, insert the plugs into the holes.
rechargIng
Battery
1. Turn off the drone and press the release button to eject the battery.
2. Plug the charging cable into the socket in the battery.
3. Plug the USB connector into a USB powered socket. When charging, the red LED goes off
and lights up again when fully charged.
4. Slide the battery into the back of the drone.
Charging time is approx. 90 minutes. Flight time is 6–8 minutes.
CAUTION: Do not charge the device unsupervised.
Controller
1. Make sure the controller is turned off and plug the power cable into the socket.
2. Plug the USB connector into a powered USB socket. The green LED is lit when charging.
When charging, the red LED on the power cable goes off and lights up again when fully
charged.
flIght featureS
Connecting the controller to the drone
Push the power control joystick fully up. The LEDs on the drone start flashing to indicate
that the remote is now connected. Press the take-off button to start the motors and move
the power control joystick slowly upwards to begin take-off.
Basic flight controls
The left joystick controls height and the right joystick controls direction (forward, back-
wards, left right).
