9
Troubleshooting
9.5
Blockage in the conveyor machine
136
9.5.4
Recommissioning after blockage removal
1.
Check all delivery hoses and hose couplings.
2.
Re-install the hose line and connect it to the machine (see Section 7.4).
➢
Defective hoses and couplings that lead to blockages or danger
must not be put back into operation.
3.
Carry out a safety check. The machine can then be put back into
operation.
9.5.5
Avoiding blockage
In order to avoid blockages, care must be taken when designing the delivery
line and the composition of the mixture to ensure that
−
use the delivery hoses tied up on the outside,
−
use delivery hoses with a larger nominal diameter,
−
produce mix with sufficient consistency.
As soon as you notice that the mix is conveyed only insufficiently or not at
all, you can:
−
add more water if the mix is too dry,
−
replace defective or dirty hose couplings,
➢
The water escapes from the hose couplings due to defective or
leaking hose couplings
−
check the hose couplings and, if necessary, clean the couplings,
replace the seals or replace the hose couplings
Summary of Contents for alpha CR
