Maintenance
10
Maintenance schedules 10.5
147
Personne
l
Interval
Maintenance
Comment
Daily
Check the sealing
cone of the vessel
ventilation.
Check sealing cone for tightness, clean and
readjust if necessary.
If the sealing cone is damaged, have it
replaced in a specialist workshop.
Daily
Check the lubricating
nipple of the feeder,
lubricate if necessary.
Grease the feeder regularly.
To do this, lubricate the grease nipples with 2
blows from the grease gun.
Daily
Cleaning the cooler
Clean cooler with compressed air.
Take care not to damage or bend the cooling
fins.
Daily
Check the fill level of
the central lubrication
system.
Check central
lubrication for
function.
Fill up central lubrication if necessary.
Observe the lubrication schedule.
Lubricant/s:
BMS
KL2K DIN 51502
Weekly
Check V-belt and
power belts.
Tighten V-belts if necessary.
Have damaged belts replaced in a specialist
workshop.
Weekly
Check the upper and
lower air lines for dirt
and clean them if
necessary.
Air lines must be removed (see Section 8.5.4)
Weekly
Check check valves
for dirt.
The non-return valves can be checked for
soiling by looking into the connections with the
top and bottom air hoses removed. If they are
dirty, clean the non-return valves and remove
them if necessary.
Weekly
Check the vessel vent
for damage or soiling.
Remove the cover of the vessel vent on the
dome cover and clean the vessel ventilation. If
necessary, have damaged parts replaced in a
specialist workshop.
Weekly
Visual inspection of
the wear plates.
Never work off the wear plates so far that the
vessel wall is already exposed.
Weekly
Visual inspection of
the mixing unit for
damage.
Replace opened or cracked mixing blades
immediately.
Note:
Danger of damage to the mixing unit.
In case of damage, contact a specialist
workshop.
Summary of Contents for alpha CR
