Attaching TV to Mount
3
1.
Hold TV firmly at each side and align the attached Inner Rails with the Outer Rails.
2.
Slide the top end of Grid Plate inwards into Receiving Tray then push bottom into
tray and slowly slide down into place.
3.
Place Cylinder Lock into housing and turn clockwise to secure.
Do not over tighten.
Attaching Receiver Tray to Wall
*Rail Plate Not Shown
1
Parts Description on Back Page
Side View
1
2
3
1.
Remove grid plate from receiving tray by turning cylinder lock counter clockwise until
free from housing. Push grid plate upwards until bottom portion is clear from receiving
tray and pull out and down.
2.
Locate center of wall studs. (NOTE: If studs are not 16" on centers, backing or internal
wall plate may be needed)
3.
Place level on top of receiving tray to determine placement.
4.
With a pencil, mark location of the holes to be drilled.
5.
Drill 1/4" pilot holes in center of wall stud in each marked location.
6.
Insert lag bolts and SAE washers into pilot holes, using 9/16" wrench to loosely tighten.
7.
Level the receiving tray and then securely tighten the lag bolts.
A
Distance
Attaching to T.V.
Attaching Rails
2
1.
Turn TV upside down and place it flat on a soft cloth or packaging material. Be sure
that area is a level and sturdy surface.
2.
Align Grid Plate with the VESA hole pattern on back of TV, place fender washers over
each mounting insert and attach machine screws with Phillips head screw driver. (
DO
NOT OVERTIGHTEN
as this can cause serious damage to the TV)
1
2
5
3
6
4
1
2
5
3
6
4
Side View
1
2
3
