Rear wheel on wheel car-
rier
Tightening sequence: Tight-
en diagonally
44 lb/ft (60 Nm)
Remove rear wheel stand.
Front wheel stand
The BMW Motorrad front
wheel stand is not designed
for holding motorcycles without a
center or other auxiliary stands. A
motorcycle standing on the front
wheel stand and the rear wheel
alone can fall over.
Place the motorcycle on the cen-
ter stand or an auxiliary stand
before lifting it with the BMW
Motorrad front wheel stand.
Make sure ground is level and
firm and park motorcycle.
Use basic stand with tool num-
ber (0 402 241) in combina-
tion with front-wheel adapter
(0 402 242).
Loosen adjusting screws
1
.
Push two mounts
2
far enough
apart that front forks fit be-
tween them.
Use locating pins
3
to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts
2
so that
front forks rest securely on
them.
Tighten adjusting screws
1
.
8
88
z
ProCarManuals.com
Summary of Contents for HP2 Megamoto
