E
ve
ryth
ing un
de
r co
nt
rol
82
Displaying the urgency of malfunctions
Depending on the equipment, the stored Check
Control messages are also displayed with the
following symbols:
No malfunctions detected in the moni-
tored systems.
Malfunctions detected in the monitored
systems. Depending on the malfunction,
supplementary information is shown on
the Control Display.
The symbols also indicate the status of the ser-
vice requirements display, refer to page
Displays after completion of trip
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can press the CHECK
button repeatedly.
The display:
>
turns off automatically after a brief period
>
can be turned off at any time by pressing
the CHECK button again for approx. 2 sec-
onds
Speed limit
You can enter a speed and a Check Control
message indicates when you have reached
this speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
You are only warned of reaching this speed a
second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.
Displaying, setting or changing limit
iDrive, for explanation of principle, refer to
page
.
1.
Open the start menu.
2.
Open "Navigation".
Without navigation system
*
:
Open "Car Data".
3.
Select "Car Data" and press the controller.
4.
Select "Limit" and press the controller.
5.
Select the speed value and press the con-
troller.
6.
Turn the controller to set the limit. If neces-
sary, hold it against a slight resistance to
enter a greater difference.
7.
Press the controller to apply the setting.
The limit is automatically switched on.
Applying your current speed as limit
Select "Select current speed" and press the
controller. The system applies your current
speed as the limit.
Activating limit
Select "On" and press the controller.
The limit is automatically switched on.
Online Edition for Part no. 01 41 0 012 832 - © 08/06 BMW AG
Online Edition for Part no. 01 41 0 012 832 - © 08/06 BMW AG
