Lights
Switching on the side
lights
The side lights switch on
automatically when the
ignition is switched on.
The side lights place a
strain on the battery.
Do not switch the ignition
on for longer than absolutely
necessary.
Switching on the low-
beam headlight
The low-beam headlight
switches on automatically
when you start the engine.
When the engine is not
running you can switch
on the lights by switching on
the ignition and either switch-
ing on the high-beam head-
light or operating the head-
light flasher.
Switching on high-beam
headlight
Press the top section of
switch
1
for the high-beam
headlight.
High-beam headlight
switched on.
Move switch
1
for the
high-beam headlight to the
centre position.
High-beam headlight
switched off.
Press the bottom section of
switch
1
for the high-beam
headlight.
The high-beam headlight
is switched on until you re-
lease the button (headlight
flasher).
Switching on parking
lights
Switch off the ignition.
You can switch on the
parking lights only imme-
diately after switching off the
ignition.
Press and hold down but-
ton
1
for the left turn indic-
4
40
z
Operation
Summary of Contents for HP2 ENDURO
