background image

Tracking Adjustment

Instructions:

Note: Tracking adjustment can only be performed with the stroller

fork locked out (Jog Mode). Roll test the stroller as described

below. It is recommended you have someone assist with this

task in order to catch and return the stroller. Fig. 12 illustrates

the roll test process.

a. Empty the stroller.

 WARNING: Do not roll test with a child or any occupant in the stroller.

b. Find a location on level ground approximately 16 ft. long. It is helpful to use an existing

straight-line as a frame of reference such as the edge of the sidewalk or a painted line

in a playground.

c. Align the stroller so the rear wheel axles are perpendicular to the straight line. Push

and release the stroller, trying carefully not to influence its direction to the left or right,

so it rolls straight down the test path. This step should be performed more than once

to make sure the stroller was not biased left or right by the pushing action.

d. If the stroller consistently pulls to the left or right when pushed straight, proceed with

the steps below until tracking is satisfactory. Fig. 12 illustrates how to interpret the

results.

Reference convention:

 Left and right are described as viewed from the operator’s

frame of reference (behind the stroller). Example: The swivel lockout knob is on the left

side of the stroller.
Fine tune tracking of stroller is accomplished by using the tracking adjustment knob

shown in Fig. 13.  If your stroller pulls to the left, turn the knob counter-clockwise 1/2

turn.  If your stroller pulls to the right, turn the knob clockwise 1/2 turn. Repeat roll test

and adjustment until the stroller rolls straight.

8.  PARKING BRAKE:

The brake is a parking brake, it prevents the stroller from moving while loading and

unloading. The parking brake is not designed as a stopping brake.

 WARNING: Do not use the brake to slow or stop the stroller because doing so

could cause the stroller to stop abruptly, resulting in loss of control.
 WARNING: The brake is intended to park the stroller on flat surfaces, not on

inclines.  Never leave your child in the stroller unattended with or without the

parking brake set!

To set the parking brake, press the brake bar down into the locked position (Fig. 14)

with your foot on the red foot pedal – making sure the locking pin fully engages the

locking disk.  To ensure the brake is set properly, attempt to roll the stroller fore and aft

after setting the brake.  If the stroller will not roll, the brake is set properly.  To release

the parking brake, lift up on the red foot pedal with your foot until the brake bar springs

up into the fully unlocked position (Fig. 15).

9.  SUN CANOPY:

The stroller features a two position canopy. To fully open the canopy, rotate the assembly

forward until the fabric is taut. The rear canopy flap should be freed from the Velcro to

give additional sun protection.  To reduce the size of the sun canopy, pull the canopy

toward the handlebar. The additional fabric can be gathered by pulling the canopy

drawstring (Fig. 1) and securing the cord lock.

10.  SEAT SAFETY HARNESS:
 WARNING: Set parking brake before placing child in stroller.

To secure your child in the seat, put one shoulder strap over each shoulder and snap

the male buckle into the female receiver on the crotch strap (Fig. 16).  Adjust shoulder

straps to be snug and secure (Fig. 17).  Connect the sternum strap (red), see Fig. 18.

 WARNING: Never place passengers in the stroller without securing them in the

harness. Unrestrained passengers can affect the control of the stroller.

Passenger weight limit - 70 lbs (32 kg)

Passenger height limit -  44 in (112 cm)

For heavier and or taller passengers (closer to the maximum limits above), auxiliary

harness anchors may be utilized by unfolding anchor Velcro (Fig. 17), sliding ladder

lock buckles above anchors, and reconnecting Velcro to keep ladder lock buckles in

place.

11.  RECLINING SEAT:
 WARNING: Set parking brake before making any seat adjustments.

To partially recline the seat, rotate the ladder lock buckles forward thus releasing the

reclining straps. (Fig 19)

To fully recline the seat, unfasten side release buckles at seat back. (Fig. 20)

Shoulder

Strap

Crotch

Strap

Buckle

Fig. 16 

Place straps over shoulders

and secure to buckle.

Fig. 13

 Tracking Adjustment.

Tracking

Adjustment

Knob

Fork

Fig. 15 

Parking Brake - Unlocked position.

Brake Bar

(Unlocked Position)

Fig. 14 

Parking Brake - Locked position.

Locking

Disk

Brake Bar

(Locked Position)

Locking

Pin

(Engaged)

Red Foot Pedal

OMS05A

P4

Fig. 12 

Stroller roll test.

16’

Stroller pulls

to left

90

o

Wheel axles

perpendicular

to straight line

Stroller pulls

to right

Top View Of Stroller

Summary of Contents for OMS05A







Reviews: