Safety information
Battery and charging
Laser safety information
Applied standard
Lidar of the product complies with the IEC 60825-1:2014 (Third Edition)
GB4706.1-2005, GB4706.7-2014, GB 4343.1-2018
01.Do not use any battery, charging stand or charger from third-party.
02.Please make sure that the voltage used is correct.
03.Do not disassemble, repair or modify the battery or the charging stand.
04.Do not place the charging stand and the main machine close to the heat source, such as heating radiators, induction cookers,
ovens, etc.
05.Do not wipe anywhere of the product with a damp cloth or any liquid.
06.Do not discard used batteries at will and please give the professional recycling agency for treatment.
07.If the power cord is damaged or broken, please stop using it immediately, and contact us in time to select the proper channel
to purchase the genuine power cord for replacement.
08.Please make sure that the main machine is turned off for transport and it is recommended to pack with the original box.
09.If the product is not used for a long time, please turn off the power after fully charged, turn off the main machine, st or e in a
cool dry place, and charge it at least every 3 months to avoid damage to the battery.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
unde-sired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
20
BOBOT ROBOTICS INC.
Safety Information
