3
between the rear tabs of
[5],
then close/glue. Add part
[7B]
. Insert/glue the fuselage
frame in such a way that the prop shaft (a cocktail stick) inserted, marries with the
hole up front in the flap of
[3.
Join
[5]
to rear of
[2]
(if the rear part of the fuselage
frame is in the way, the rear portion – D and E can be cut off and discarded).
6. Paste Doors
[9]
over the doors of the plane.
Main Wing
7. Assemble parts
[10L], [10R],
spars and struts
[11L], [11R]
and
[12]
.
8. Glue a
[12]
in place in each
[11]
as well as at their inner ends. Join/glue the two
spars together, so that they form an angle of 2x2.5° to each other (use the decal
provided).
9. Glue the 2 wings
[10]
in place.
10. Glue assembled wing in place: Cut out the green area on top of the cockpit, and a
small portion of the bulkheads, so that the wing fits snugly in place.
11. Glue the Inclined Spars (Fuselage to Wing)
[14]
in place.
Undercarriage
12. Roll/glue Undercarriage Spars
[15]
. Insert through relevant holes in Fuselage with
inside ends liberally glued. Glue exit from fuselage liberally.
13. Assemble and glue front wheel in place.
Varia
14. Add Cover flashing
[13],
which covers join between the 2 wing parts, as well as the
join fuselage-wing.
15. Glue the 2 exhausts
[16]
in position.
---oooOooo—
