ASSEMBLY INSTRUCTIONS &
PARTS IDENTIFICATION
ELEVATIONS UPH COUNTER STOOL
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that may have come
loose inside the carton during shipment.
Parts key
f
No
Hardware kit
:
No
Code
Qty
Description
1
1851-BS420KDBDFP40 1
pc
I
ChairBack
2 ·ja51-8S420KDBDFP4 t 1
pc
Complete Seat
3 ·lss1-ss420K
□
BDFP42 1 pc
Right Facmg Front Leg
4
JB51-BS420KDBDFP43 1
pc
Left Facmg Front Leg
5
1B51-BS420KDBDFP441
pc
6 1B51-BS420KDBDFP45 1 pc Left facing side stretcher
7 1B51-BS420KDBDFP49 1 pc Front Stretcher
A
(!I
', B
0
-
y-
-
�
-
E
.,,
F
�
G
�
H
8
1851P01F
_
4
_
P
_
cs
__
F
_
lo
_
o
_
rG
_
l
_
ide
-------�
�
• Fabric Content: 100% POLYESTER
[STEP 11
Hex nut
Lock washer
Flat washer
Long bolt
Short bolt
Allen key
Key wrench
V\-bod Screw
#1851 - 8S420KDBDFP46
Description
Qty
M8
4 pcs
08
11 pcs
08 x 18mm 11 pcs
M6 X 8QTirn
4 pcs
M6 x40rnrn 3 pcs
l<.4
1 pc
13
1 pc
04 x40rnrn 6 pcs
• Cleaning Codes: C!ean only with dry cleaning solvent. Do not
saturate. Do not use water. Pile fabrics may require brushing
to restore appearance.
- Carefully lay Chair Back flat on a smooth fiat surface to prevent scratches.
(
2
\
\.,
.
[STEP 21
-Attach Complete Seat to Chair Back by inserting a Flat Washer, Lock
Washer and Short boll into each of the hole on the back of the seat.
Tighten screws with provided Allen Key by turning clockwise until secure.
(See Detail A).
- Insert a Flat Washer, Lock Washer an Long screw into each of 2 holes in
the Complete Seat corners. Tighten sc1ews with provided Key Wrench.
( See Detail B).
- Carefully turn chair upside down and attach each Front Leg to lhe front
corners d the Complete Seat (Keeping in mind of the right side and left side
leg) with a Flat Washer (C), Lock Washer (B) and Nut (A). (See detail C).
Keep nut loose at this point. Insert right side stretcher and left side stretcher
between the Front and Back Legs, then insert the Front Stretcher between
the two Front Legs. (Make sure that the side stretchers are not at an angle
as the front legs are on the wrong side). Fasten stretchers to legs with
Screws (I) using a Screwdriver (not provide).
-Be sure to level the chair prior to tightening front leg nuts with wrench
provided (G).
MADE IN VIET NAM
