Bob’s Space Racers® Inc. ©2017
P a g e
|
5
G
AME POWER MUST BE ON TO PERFORM THIS OPERATION
.
Please Note: Read all the instructions before performing any procedures.
2.1.4
Plug in all the cables. See
Figure 2.6
.
2.1.5
Go to the
Master
board and enter programming mode by mode pressing and holding the
Select
and
Enter
on the
Master
board (
Figure 2.7)
until
Figure 2.8
is visible.
(This should be about 5
seconds)
.
2.1.6
Release the two buttons
Please Note: There is a safety protocol. Two minutes after entering into program mode it will exit automatically. If it
exits before accomplishing the procedure the master saves the last entry. Simply re-access program mode and continue
where it timed out.
2.1.7
The
Spare Unit
board’s ID will now show 33 as seen in
Figure 2.9
.
Figure 2.9
Figure 2.7
Select
Enter
Figure 2.8
Figure 2.6
Network
Cables
Network
Cables
Power
Connector
1. Each connector is keyed.
2. Connections may vary per game.
