5
Getting Started
Required Tools:
A pair of long nose pliers.
Diagonal Cutters or sharp knife to trim nylon ties.
Calipers or measuring tape to measure part placement.
#3 Phillips screwdriver to build the main components.
220 grit sandpaper to remove laser marks on wood pieces (if desired).
LOCTITE 242
™
thread lock (fingernail polish can be used as a substitute).
Set of Metric Sockets and SAE Wrenches.
Set of Metric and SAE Allen Wrenches.
Assembly Recommendations:
Use a large, flat, clean work surface for assembling your EVOLUTION.
All Screws (unless noted) should be installed snug, then rotated 1-2 ½
turns.
Apply LOCTITE to all M4 X 16 mm Machine Screw that are used to secure
plywood pieces except for the 4 screws that clamp the router in step 10 of
the final assembly.
Light sanding may be required to remove any marks made by the laser.
Painting, or applying stain with a clear coat will provide extra protection to
the wood components.