With bObi on the ground look at the remote’s
screen.
The 4 bars below numbers 1 to 4 should be
underlined. Lift bObi about 6 inches (15 cm)
off the ground and the lines below numbers
1 to 4 disappear, while numbers 5 and 6 are
underlined.
Step 1: 0000
Edge and Wheel Sensors
Step 2: 0001
Firmware Version
Step 3: 0002
Battery
Press RGHT on the remote and the Checkup
Indicator changes to 0100.
Drag a thick, flat, and light-colored surface
around bObi’s bumper. Numbers 1 to 5 at the
top of the remote will become underlined one
at a time as you move your surface from the left
side of bObi’s bumper around to the right side.
The far right sensor is less sensitive than the
others, so it may not respond the first few
passes.
Step 4: 0100
Wall Sensors
Home Checkup Test
!
Quick Tip:
Press LEFT on the remote. The Checkup
Indicator changes to 0001.
The four-digit number in the center of the screen
indicates bObi’s firmware version.
Press LEFT on the remote and Checkup
Indicator changes to 0002.
The four-digit number in the center of the screen
indicates the battery voltage in millivolts (mv).
A fully charged battery should have a voltage
between 1200 and 1600 mv. If the number
is below 1200, charge bObi overnight and
repeat the test. If bObi is fully charged and the
number is 0000 mv, flip bObi, open the battery
compartment, and check the wiring connectivity.
bObi should not be tested while on the charging station.
To exit the checkup test, flip Bob’s power switch OFF and then ON.
84
83
