CS6140, CS6140B Series Turning machine
Instructions
11-10
When removing the chuck or driving plate from the spindle nose, loosen nut (1) and 2 screws (2), and keep
rotating retainer ring (3).
No matter whether chuck or driving plate is used 2 screws (2) should be tightened completely. Otherwise they
may make noise during spindle rotation. The six cams with a key aligning reference line 1 with reference line 2.
See Fig. 11-11 for structure of spindle nose.
11.8.2 Chuck, driving plate and spindle nose of CS6140B series
Chuck or driving plate is mounted and connected onto the spindle by a short taper cam lock.
When mounting, align reference line 2 on cam (4) with reference line 1 on spindle nose; align reference line 3 on
studs of chuck or driving plate with left face of chuck or driving plate; tighten them with screw (6). Insert six studs of
chuck or driving plate into six holes in spindle nose and turn the six cams with the square key supplied till they are
locked.
When removing the chuck or driving plate from the spindle nose, loosen the six cams with a key aligning
reference line 1 with reference line 2. A face plate is mounted onto or removed from the spindle nose in the same
way as the chuck or driving plate.
See Fig. 11-12 for structure of spindle nose.
Fig. 11-11a Mounting of chuck or driving plate onto spindle ISO702
/
Ⅲ
No.6
Summary of Contents for CS6140 Series
