CS6140, CS6140B Series Turning Machine Instructions
1-3
1.2 Additional Safety Rules for machine
WARNING! When using electric tools basic safety precautions should always be followed to reduce the
risk of fire, electrical shock and personal injury including the following:
Read all these instructions before attempting to operate this product and save these instructions.
1) Operating speed of spindle should not exceed permissible speed of chuck (See Operator’
s Manual of Chuck).
2) Do not use a turning tool that is damaged or deformed or unsharp.
3) Be sure that the machine is disconnected from the power when adjusting, maintenance and repair.
4) Be sure to switch off the machine when performing periodical maintenance or service.
5) Release the carriage by loosing the lock screws before moving it longitudinally.
6) Add oil or grease to every oil site including guideways, oil cups and 3 cases for ensuring safe and normal
operation.
7) Use special tools to install turning tool.
8) Wear suitable personal protective equipment when necessary, this could include:
- Eye protection safety goggles
- .Safety hat or headgear for long hair
- Tight work uniform from head to foot
- Safety shoes
- Hearing protection
9) When turning a slender
shaft work
, recommend to fasten it with a follow rest, or steady rest or tailstock to prevent
it from getting off.
10) Put the machine on a solid foundation.
11) Never machine flammable materials (like magnesium bar)
12) Always use in a well-ventilated area. Remove dust frequently. Clean out dust from the interior to prevent a
potential hazard.
13) Store idle tools. When not in use, tools should be stored in a dry locked-up place, out of reach of children.
14) Keep the cord away from heat, oil and sharp edges.
15) Stay alert. Watch what you are doing, use common sense and do not operate the tool when you are tired.
16) Inspect the cords and extension cords periodically and if damaged have them repaired or replaced.
17) Have the machine repaired by a qualified person. Using of electric tools should compliy with the relevant rules.
18) Repair of important parts should only be carried out by qualified persons using original spare parts, otherwise
Summary of Contents for CS6140 Series
