SETTING IN OPERATION
Quartz movement
1/ Battery operated quartz clocks :
Set the 2 X 1,5 V. alkaline batteries taking care of the correct polarity, set the switch (8) on
ON, the clocks starts immediately.
To synchronize on the second :
Set the clock manually 1 minute early ; on the flap fall, press the “Stop” button (7) and keep
it depressed ; on the time signal release it ; the clock is synchronized on the second.
2/ Mains operated quartz clocks :
Set the switch (8) on ON position : the clock starts immediately. To synchronize on the
second : id. 1 above.
Slave movement
Wait for 2 impulses in order to get the movement on the right polarity and set the clock on
time according to above.
CONNECTION
All electrical connections are made on the wall plate.
The clock is automatically connected by plug-in when set on the wall plate.
The motor of the automatic calendar is supplied by 2 alkaline batteries R 14. Before the
setting on time, set the batteries as shown on fig. 4.
Power reserve quartz
Connect the mains wires on 2 & 3.
The clock operates on voltages from 100 to 250 V. AC.
12/24 V, min. and 1/2 min. impulse slave movement (type 5)
12 V. imp. : 2 shunts between 5-6 and 7-8.
I = 27 mA.
24 V. imp. : 1 shunt between 6-7. I = 13 mA.
48 V. imp. : Insert 1 2200n resistor between 6-7. I = 13 mA.
1/2 min. serie[s] slave movement (type 6)
Set a 100R resistor between 5-8.
If necessary adapt the value of the resistor. Coil consumption : 45 mA, 3 V.
Hourly reset slave movement SR2 21/31 V. min. imp.
(Simplex / IBM, type 7) and 24 V. DC non polar mvt
Caution : Make sure that the impulse polarity is correct.
Consumption : 45 mA at 24 V.
The SR2 movement can be adapted to SR3 (3 wires) by removing the diode located on
the PCB of the movement coil.
Connection becomes :
CAUTION
For any transport : Put a protective sheet onto the flaps : close the cover, put the clock into a nylon bag then in the original
packing or a double packing.
We will not be responsible of any damage due to incorrect packing.
For any claim or spare-parts order state on your request the control and model numbers of the clock.
[2018 OCR text of original jpg supplied by BODET - France - www.bodet-time.com ]
