29
9) Alarm messages
By default, the alarm configuration is :
-
Activated: if an alarm is present, a message is displayed on the
readout,
- Alarm relay: relay 3 is activated if an alarm is triggered.
If an alarm is active, the display alternates
between the date and the alarm message.
Press the
key to view additional
information on this alarm.
Example :
If several alarms are active simultaneously,
the display is:
Press the
key to view the additional
information.
Press the
key to view the following
alarms.
The alarms are displayed in chronological
order.
To acknowledge an alarm, press
.
Except for Afnor, DCF and GPS synchronisation failures where alarm is
activated after 24 hours, other alarms are activated immediately.
Alarm message
Meaning
user code fail.
The user code has been entered three times incorrectly; the
keyboard is blocked for 10 minutes.
tech.code fail.
The technician code has been entered three times incorrectly; the
keyboard is blocked for 10 minutes.
10:54.32 ó
Alarm :output 01 ö
24v overload on 01
18/12/07 10:54.32 ok
10:54.32 ó
Alarms ö
Alarm :output 01 ö
Alarm :output 03 õ
Summary of Contents for Sigma H
Page 3: ...3 SIGMA H Installation and start up instructions ...
Page 36: ...36 ...