34
If the clock is in mode COD, the time displayed is the time received from master clock.
If the clock is in mode LOC, the time displayed depends on the
offset selected in the Time mode menu (Seasonal change and
offset change).
DHF
: activation of the DHF synchronisation card.
nor
: normal mode, the clock is already associated to a DHF transmitter.
Press [SELECT] button to access to the dynamic
DHF synchro menu. This menu allows you to check
the time signal reception. The display shows the
construction of the time message as and when the
data arrives. Press [SELECT] button to exit this menu.
Init
: this mode forces the clock to search a DHF
transmitter. After selecting this mode, the clock
comes back to the time display, initialised to 00h00
01/01/2000. As soon as the clock finds a DHF
transmitter, the clock is synchronised and switched to “nor” mode. The
clock is now associated and synchronised by this transmitter.
5. Press on [SELECT] to access to the setting of the temperature unit.
This menu permits to choose between degree
Cesius and Fahrenheit.
Press the [SELECT] button. Adjusting the
temperature offset. Variation, using the [+] button between –9.5°C and
+9.5°C by increments of 0.5 (on leaving the factory, an adjustment can
be made).
6. Press [SELECT] to obtain the Test display menu. This menu enables you
to check that all the clock segments are giving the correct display.
7. Press [SELECT]. The Correction menu appears. This enables you to
correct the time base manually. On leaving the factory, the value of the
offset is 0. The value of this offset may vary (using the [+]) between
-9s99 and +9s99 per 10ms step (#0.12 ppm). The addition of this daily
offset to the time base will be spread over 24 hours.
8. Press [SELECT] again to exit the technician menu and return to the time
display.
Reminder
: At any time, holding down the [SELECT] button, then pressing the [+] button quickly,
goes to normal display mode and exits the configuration menu.
If no buttons are pressed for 10 minutes, the clock returns automatically to time display
mode.
