8
4/ Attach the bracket to the wall with
four 8 mm (HMT Led 15 and 20) or 10
mm (HMT Led 25) threaded rods plus
chemical sealing (recommended).
5/ Attach the double face support to the
bracket with the four 8 mm screws (C).
Remember to insert the cables in the
bracket.
6/ Open the clocks, remove the glass
and unscrew the wall attachment parts.
7/ Attach the first clock (repeater clock)
to the double face support on the 4
screws ST F M5-40 (D). Place the
6 mm washers (detail D) flat on the
double face support (and not inside the
clocks) to move the clocks sufficiently
far away and facilitate insertion of the
cables. Screw in the 2 nuts at the top
(D) without tightening, move the clock
away and insert the cables.
8/ Attach the second clock (master
clock) on the other side of the double
face support with the same 4 screws
ST F M5-40 (D). Screw in the 2 nuts at
the top (D) without tightening, move the
clock away and insert the cables. Refer
to section III Electrical Installation.
C
St. steel nut HU M8
Stainless steel 8 mm
tooth washer
St. steel screw
H M8x25
C
C
Horizontal bracket attachment
Vertical bracket attachment
Bracket
D
St. steel screw
ST F M5-40
Single face cover
St. steel 6 mm
flat washer
St. steel nut HM5