6.1 Time synchronisation menu
To configure the time synchronisation of the SIGMA, validate the option in
the technician menu with the
key,
The following screen is displayed :
Select the time synchronisation mode
from the following options:
FI/DCF Radio
,
Minute radio
(mode used for countries receiving the FI/DCF radio
signal but for which the time is different from Paris/Berlin [only minute
is synchronised, date and hour must be set manually]),
EXTERNAL
(mode used for synchronisation from a Sigma “Master”
which transmits a GPS signal simulation from an ASCII extension
card),
NONE
: if you choose to have no synchronisation, the radio
pictogram is not displayed.
GPS
,
Remark
: all the synchronisation options are proposed without
checking that an antenna is connected (by default, the configuration
is FI/DCF mode).
In case of synchronisation input failure, an alarm message is sent.
This alarm is triggered after 24 hours without synchronisation.
Select the synchronisation mode with the
and
keys and validate
with the
key.
The following screen is displayed if
“Prog” mode has been validated in the
customer menu (see “Time and date”, page 12) :
This menu can be used to program non-standard winter/summer time
changeovers.
15
Time syn
chro ok
Time out
puts õ
Syn chro:EXTERNAL ú
ok
Prog. time change:Yesú
ok