ECO-SERIES REAR BUMPER
2015-2016 FORD F150
Page 3 of 7
the vehicle, do not proceed until the bumper is fully and safely supported. Snug but do
not fully tighten hardware at this time. Skip to
Step 9
.
9.
Level and adjust the bumper and fully tighten all hardware including the Mounting Bracket to
Bumper hardware.
10.
Attach the wiring harness to the sensors, lights and trailer plug. Use the included Wire Ties to
secure the wiring harness to the bumper and frame as necessary.
11.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
12.
Use the included (2) push-in plugs to attach the license plate to the Bumper,
(Figure 17)
.
13.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Bumper assembly.
Passenger Side Installation Pictured
(Fig 1) Unplug and remove 7-wire trailer plug
Remove the factory hex
nuts attaching bumper
assembly to frame
(Fig 3A) Note bumper with integrated receiver hitch
Rear
Rear
(Fig 2) Unplug license plate lights
WARNING!
Do not crawl under bumper
unless the bumper is properly supported on
blocks or stands or the bumper may fall.
