ECO-SERIES FRONT WINCH BUMPER
2015-2016 SILVERADO 2500/3500
Page 1 of 6
10/31/16 (DP)
PARTS LIST:
1
HD Front bumper
6
10mm x 30mm x 2.5mm Flat Washers
1
Winch Tray/Bracket Assembly
6
10mm Lock Washers
2
LH Lower Support Brackets
6
10mm Hex Nuts
2
RH Lower Support Brackets
2
8-1.25mm x 16mm Hex Bolts
1
License Plate bracket
2
8-1.25mm x 25mm Hex Bolts
2
Plastic Plugs for License Plate
2
8mm Hex Nut
4
Rubber Sensor Hole Block Offs
4
8mm Lock Washer
10
Nylon Cable Ties 200mm
6
8mm x 24mm x 2mm Flat Washers
1
“L” Light bracket driver side
2
6mm x 20mm Button Head Screw
1
“L” Light bracket passenger side
2
6mm Nylon Lock Nuts
2
12-1.75mmx130mm Hex Bolts
4
6mm x 12mm x 1.2mm Flat Washers
4
12-1.75mm x 35mm Hex Bolts
1
6mm Allen Wrench
12
12mm x 24mm OD x 2.5mm Flat Washers
8
4mm x 10mm Button Head Screws
6
12mm Lock Washers
1
4mm Allen Wrench
6
12mm Hex Nuts
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. BUMPER IS HEAVY, ASSISTANCE IS
HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
1.
Open the hood and remove the plastic cover on top of the radiator and the grille,
(Figure 1)
.
Temporarily remove the plastic grille.
2.
Remove the license plate and bracket. On models with factory fog lights, unplug both lights.
On models with bumper mounted sensors, unplug all sensors. Release the wiring harnesses
from the clips attached to the back of the bumper and move all wiring harnesses away from
bumper.
License Plate Bracket
(2) D Rings
(2) License
Plate Plugs
(4) Sensor Plugs
Left and Right Bar
Light “L” Brackets
Left and Right
Support Brackets
Left and Right
Support Brackets
