POLY-V BELT
If the belt does not catch hold of the fl ywheel, it is time
for it to be tightened.
1: Remove the service hatch on both sides of the cycle
with a screwdriver, see fi gure 11.
2: Loosen the bolts (1) on both sides of the cycle with a
19 mm wrench, see fi gure 12
3: Loosen the nuts (2) on the counter bolt on both sides
of the cycle with a 10 mm wrench, see fi gure 12.
4: Use a wrench to tighten the counter bolts (3). On the
right side, the tool should be pulled downwards and on
the left side upwards to tighten with a 10 mm wrench.
5: The belt should be tightened to approximately 125
kg/229 Hz. To measure this, a special device can be
bought at your local BODY BIKE Distributor.
SERVICE HATCH
(1)
(2)
(3)
Figure 11
Figure 12
Please note:
The belt should be equally tightened
on both sides.
The fl ywheel should be parallel with
the long main side member.
