Figure 5
WASHER
A
BOTTOM FRAME
A fixing tool can be bought at BODY BIKE
International A/S to ease the mounting of
the bottom frame.
1. Arrange the bottom frames parallel on
the floor next to the cycle with the correct
mounting distance between them, see
figure 1. On the front bottom frame, the
transport wheels should point forward.
2. Take hold of the front post and seat post
and lift the cycle onto the bottom frames,
see figure1. Ensure that the holes in the
frame match the holes in the bottom frames.
3: Put on the spring lock washer and the cap
nut and tighten by using a 13 mm wrench,
see figure 2.
Please note
- Do not overtighten the nuts. They
should only be hand tight.
4: Unscrew the rubber feet a little. Place the
cycle in the correct position. Turn them up
and down until the cycle stands properly
and it is in level. Tighten the nut with a 13
mm wrench.
Figure 3
WASHER
Figure 4
Figure 1
LIFT
BACK BOTTOM
FRAME
FRONT BOTTOM FRAME WITH
WHEELS POINTING FORWARD
Figure 2
SPRING LOCK
WASHER
CAP NUT
