MAINTENANCE
If the belt does not catch hold of the flywheel, it is time
for it to be tightened.
1) Remove the service hatch on both sides of the cycle
with a screwdriver, see figure 17.
2) Loosen the bolts (1) on both sides of the cycle with a
19 mm wrench, see figure 22
3) Loosen the nuts (2) on the counter bolt on both sides
of the cycle with a 10 mm wrench, see figure 22.
4) Use a wrench to tighten the counter bolts (3). On the
right side, the tool should be pulled downwards and on
the left side upwards to tighten with a 10 mm wrench.
5: The belt should be tightened to approximately 125
kg/229 Hz. To measure this, a special device can be
bought at your local BODY BIKE® distributor. Go to
page 22
6: Tighten the counter bolt (2) on both sides of the
cycle again.
7: And tighten the bolt(1) again on both sides of the
cycle.
8: Close the cycle by fastening the two hatches again.
POLY-V BELT
PLEASE NOTE
The belt should be evenly tightened on both
sides.
The flywheel should be parallel with the long
main side member.
!
1
2
3
Figure 22
021
