Federal Communication Commission In-
terference Statement
This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential in-
stallation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio com-
munications. However, there is no guar-
antee that interference will not occur in a
particular installation. If this equipment
does cause harmful interference to ra-
dio or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
•Reorient or relocate the receiving anten-
na.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received, in-
cluding interference that may cause
undesired operation.
EU Declaration of Conformity
This device complies with the essential
requirements of the Radio Equipment
Directive, RED 2014/53/EU. The fol-
lowing test methods have been ap-
plied in order to prove presumption of
conformity with the essential require-
ments of the RED 2014/53/EU:
EN60950
EN61000-6-2
EN61000-6-3
EN 55022+EN 55024(2010)
EN 301 489-1 V1.8.1(2008-04)
EN 301 489-3V1.4.1(2002-08)
EN 300 440-2 V1.3.1(2009-03)
This device is a 2.4 GHz wideband
transmission system (transceiver),
intended for use in all EU member
states and EFTA countries, except in
France and Italy where restrictive use
applies.
In Italy the end-user should apply for a li-
cense at the national spectrum authorities in
order to obtain authorization to use the de-
vice for setting up outdoor radio links and/or
for supplying public access to telecommuni-
cations and/or network services.
This device may not be used for setting up
outdoor radio links in France and in some ar-
eas the RF output power may be limited to
10 mW EIRP in the frequency range of 2454
– 2483.5 MHz. For detailed information the
end-user should contact the national spec-
trum authority in France.
Hereby, BODY BIKE, declares that the BODY
BIKE SMART+ is in compliance with the es-
sential requirements and other relevant pro-
visions of RED 2014/53/EU.
ANT+ and Bluetooth
The SMART+ control box is compatible with
BLE/Bluetooth Smart and ANT+ certified.
CERTIFICATION
05
