1) Open the top of the box.
2) Remove all the unmounted parts.
3) Flatten the box on the floor next to the pallet.
4) Loosen the two screws mounting the first cycle to
the pallet. See figure 2
5) Lift the cycle off the pallet and place it on the flat-
tened box to spare your floor from getting marks.
UNPACKING
Figure 2
A fixing tool can be bought at BODY BIKE®
International A/S to ease the mounting of the bottom
frame. Go to page 30.
1) Arrange the bottom frames parallel on the floor
next to the cycle with the correct mounting distance
between them, see figure 3. On the front bottom
frame, the transport wheels should point forward.
2) Take hold of the front post and seat post and lift
the cycle onto the bottom frames, see figure 3. Ensure
that the holes in the frame match the holes in the
bottom frames.
3) Put on the spring lock washer and the 8mm bolt
and tighten by using a 5 mm Allen wrench, see figure
4.
4) Unscrew the rubber feet a little. Place the cycle in
the correct position. Turn them up and down until the
cycle stands properly and it is in level.
BOTTOM FRAME
PLEASE NOTE
Do not overtighten the nuts. Max 12 Nm.
!
A
SSEMBL
Y
09
