BR2117 BR3151
Page 13
Assembly STEP 7
Hardware Required
THE ASSEMBLY PROCESS IS NOW COMPLETE.
However, for your own safety, please make sure to read this entire Owner’s Manual which
includes safety instructions and warnings, as well as any safety/warning labels affixed to the
product before use. For your safety , please visually and functionally inspect and test the unit
after assembly is complete.
PULSE HANDLEBAR ASSEMBLY
Install the
Pulse Handle Bar (#05)
onto the front side of the
Center
Post (#02)
as shown in the illustration below using two
Bolts (#19)
and two
Washers (#29)
. Please ensure the
Hand Pulse Wire (#13)
is
free and clear, avoiding pinching it during this assembly step. You will
need to connect this wire to the
Monitor (#46)
later. Attach the
Clamp
Cover (#24)
onto the
Pulse Handle Bar (#05)
as illustrated.
COMPUTER ASSEMBLY
Remove the four
Screws (#25)
that are pre-assembled on the
Monitor
(#46)
. Set them aside nearby as they will be used later in this process.
With the help of an assistant, connect the
Main Sensor
Wire (Middle) (#11)
to the corresponding wire on the
Monitor (#46)
(diagram A). Connect the end of
Hand Pulse Wire (#13)
the back hole
as illustrated below (diagram B). to the
Monitor (#46)
. Being careful
not to pinch/damage any of the wires, tuck in the connected wires
through the mouth of
Center Post (#02)
and attach the
Monitor (#46)
to the bracket on the
Center Post (#02)
by using the four
Screws
(#25)
that were previously removed.
#19. Bolt (M8x30 mm)
[2 Pieces]
#29. Spring Washer (M8)
[2 pieces]
#24. Clamp Cover
[1 Piece]
#25. Screw (M5x10 mm)
[4 Pieces]
