BRB 3800
A s s e m b l y S t e p 1
Page 5
H a r d w a r e R e q u i r e d
A
B
C
A.) Stabilizer Assembly
Align the
Front Stabilizer (#10)
to the
Main Frame (#01)
. Attach
them together by inserting two
Carriage Bolts (#12)
through the
Front Stabilizer (#10)
followed by the
Main Frame (#01)
. Secure
them together using two
Arc Washers (#22)
, two
Spring Washers
(#21)
and two
Nuts (#26).
Please Note that the
Front Stabilizer (#10)
is the one with end
caps that spin.
B.) Stabilizer Assembly
Align the
Rear Stabilizer (#11)
to the
Bottom Frame (#02)
. Attach
them together by inserting two
Carriage Bolts (#12)
through the
Rear Stabilizer (#11)
followed by the
Bottom Frame (#02)
. Secure
them together using two
Arc Washers (#22)
, two
Spring Washers
(#21)
and two
Nuts (#26)
.
C.) Frame Assembly
Connect
Sensor Wire 3 (#43)
to
Sensor Wire 4 (#44)
. Pull up the
Spring Loaded Knob (#27)
and slide the
Bottom Frame (#02)
into the Main
Frame (#01)
. Slide the
Bottom Frame (#02)
further
into the
Main Frame (#01)
for shorter users and further out for
taller users. Once you select the desired setting, screw the
Spring
Loaded Knob (#27)
into the
Main Frame (#01)
and through the
Bottom Frame (#02)
to secure it in place. Tighten them using two
Screws (#20).
#12. Carriage Bolt (M8x70 mm)
[4 Pieces]
#20. Screw (M5x8 mm)
[2 Pieces]
Washer
#22. Arc Washer (M8)
[4 Pieces]
#21. Spring Washer (M8)
[4 Pieces]
Nut
#26. Nut (M8)
[4 Pieces]
Bolt
Assembly Instructions
