Body Champ BRM 3680, Owner'S Manual

W A R N I N G

Do not remove the 

Seat (#36)

 for any 

reason after you have installed it.

Exercising on this unit without the 

Seat

(#36)

 can result in SERIOUS INJURY.  

Ensure the seat is locked in place by 

tightening the two knobs prior to use.

Page 10 

A s s e m b l y   S t e p  6

Remove the three 

Washers (#44) 

and three 

Nylon Nuts (#41)

 that 

are pre-assembled on the bottom of the 

Seat (#36) 

and set them 

aside as they will be used later in this step.  

Attach the 

Seat (#36) 

onto the 

Horizontal Seat Bar (#11) 

and 

make sure that the 

Seat (#36) 

is pointing directly toward the short 

end of it and then tighten with three 

Washers (#44) 

and three 

Nylon Nuts (#41) 

that were previously removed.     

 
Referring to Diagram A below, please unscrew and remove 

Knob 

Bolt (#28) 

from 

Seat Post (#10) 

e

d

il

s

d

n

a

  t

r

e

s

n

i 

,

n

e

h

T

 .

Horizontal 

Seat Bar (#11)

  in through 

Seat Post (#11) 

as llustrated in the 

diagram. Align the corresponding holes on 

Seat Post (#10) 

and 

Horizontal Seat Bar (#11) 

to your desired setting and secure the 

parts by inserting 

Knob Bolt (#28)

 through both parts and tighten. 

For safety purposes, please ensure all parts are secure.    

Insert the 

Seat Post (#10) 

into the mouth of the post that is 

protruding from the 

Main Frame (#01) 

down a minimum of 4 inches 

to engage the lowest hole. Make sure the holes on the 

Seat Post 

(#10) 

are facing the 

front 

before inserting. You can adjust to your       

Secure the 

Seat Post (#10) 

(now with 

Seat (#36) 

attached) using

 the (previously removed) 

Knob Bolt (#28).

Plug in the 

AC Adapter (#46) 

male plug into the female socket

located at the rear of the unit as shown below. 

Now, please unscrew and remove 

Knob Bolt (#28) 

from metal post 

on the 

Main Frame (#01).

The assembly process is now complete. 

However, 

for your own safety, please make 

sure to read this entire Owner’s Manual which includes safety instructions and 

warnings, as well as any safety/warning labels affixed to the product before use.  

For your safety, please visually and functionally inspect and test the unit 

after assembly is complete.

Hardware Required

Washer

#44. Washer (M8

)

          [3 Pieces]

Nut

#41. Nylon Nut (M8)

[3 Pieces]

A

Assembly Instructions

BRM 3680/3689 

desired height setting after complete assembly.