Assembly Instructions
Page 9
#42. Washer
[1 pieces]
#43. Knob (M10)
[1 piece]
#39. Spring Loaded Knob
[1 piece]
r
e
h
s
a
W
.
3
7
#
[3 pieces]
#72. Nylon
t
u
N
[3 pieces]
A s s e m b l y S t e p 6
Hardware Required
Tool Required
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust seat simultane-
ously
Push knob back inward until it clicks and then
tighten it by turning clockwise.
#42 WASHER FOR M10 BOLT,T2.0 1PC
W A R N I N G
Do not remove the Seat (#33) for any
reason after you have installed it.
Exercising on this unit without the Seat
(#33) can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
S13
BRM3671/3681/3690
Seat Assembly
Remove the Washers and Nuts that are pre-assembled on the
back of the Seat (#33) and set them aside as they will be used
in later in this process. Attach the Seat (#33) onto the Horizontal
Seat Bar (#35), ensuring that it is pointing directly toward the
short end of it and then
tighten with three Washers (#73)
and three Nylon Nuts (#72) that were previously removed.
Horizontal Seat Bar (#35) onto the Seat Post (#36)
by inserting the bolt (on the bottom of the
Horizontal Seat Bar
(#35 ) through the Seat Post (#36), secure them using a
adjust the distance of the seat from the
Washer (#42) and a Knob (#43). This knob can be loosened to
handle bars. Make
sure to tighten the knob after making any adjustment.
Attach the
Insert the Seat Post (#36) into the mouth of the post that is protruding
from the Main Frame (#48) down a minimum of 4 inches to engage
the lowest hole. Please ensure that the hole on the Seat Post (#36)
facing the same side as the Spring
Loaded Knob (#39) so it can be
aligned and fully engage through the lowest corresponding hold on the
Main Frame (#48). Screw in the Spring
Loaded Knob (#39) through
the Main Frame (#48) post and fully through (at minimum) the
lowest hole located on the Seat Post (#36). Please refer to illustration.
You may adjust the Seat Post (#36) to the height most comfortable for
you after complete assembly. Please always check to ensure a hole
has been fully engaged when you secure and tighten the Spring
Loaded Knob (#39).
The Spring Loaded Knob (#39) has a safety
feature that allows you to loosen it by turning it
counter-clockwise three times as you pull outward.
Adjust the seat height and then pop the knob back
in. Tighten the knob by turning clockwise. Please
refer to illustration below.
