Setting up Your SensaTONE
Check you have the following contents:
• 1 x SensaTONE unit
• 1 x SensaTONE vaginal probe
• 1 x Leadwire
• 1 x Lubricant gel sachet
• 2 x AAA batteries
• 1 x Carrying pouch
• 1 x Neck cord
The Assembly Stage
1. Slide open the battery cover on the back of the
unit to expose the battery compartment.
2. Insert the batteries according to the diagram
found in the battery compartment. Replace the
cover.
3. Remove the SensaTONE vaginal probe from its
packaging.
4. Wash hands in soap and warm running water.
Liberally wash the probe using the same
method but do not soak. Rinse all soap and
residue from hands and probe. Dry the probe
with a clean cloth/paper towel and allow to air
dry.
5. Ensure that the SensaTONE is switched off.
6. Insert the end of the leadwire into the socket at
the bottom of the SensaTONE. Connect the
other end of the leadwire to the probe.
See diagram (i) on page 7.
7. Apply a thin coating of lubricating gel to
the probe.
8. Insert the probe until the flange at the base of
the probe is sited between the labia. There is no
need for precise orientation. See diagram (ii) on
page 7.
9. You are now ready to begin stimulation.
6
Bodyclock Sensatone Inst 3.qx8_Bodyclock Sensatone Instr 14/07/2010 11:26 Page 6
