Page 6
Hardware Required
Make sure this wire is
hanging out before
assembling the
Front
Post (#02).
#16. Bolt
(M8×16 mm)
[4 Pieces]
#56. Arc Washer (M8,R25)
[4 Pieces]
Bolts
Washers
A s s e m b l y S t e p 2
Remove the four
Bolts (#16)
and four
Arc Washers (#56)
that were
pre-assembled on the
Main Frame (#01)
and set them aside as they
will be used later in this step.
Connect the
Main sensor Wire (Middle) (#18b)
to the
Main Sensor
Wire (Lower) (#20)
and then follow the instructions in the diagram
below to connect the
Tension Wire (#19).
After connecting the
Tension
Wire (#19)
to the
Tension Controller (#17)
slide the
Front Post (#02)
onto the
Main Frame (#01)
making sure not to pinch the wires and secure
using the four
Bolts (#16)
and four
Arc Washers (#56)
that were
TENSION WIRE ASSEMBLY
Insert the tip of the
Tension
Controller (17)
wire into the
Tension
Wire (19)
head at an angle. Tilt the
Tension controller (17)
wire into the
crevice and then pull upward.
Assembly Instructions
previously removed.
BRM2170/2180