За упътване на български вижте по-долу
Use instruction for pedal exerciser
1. Take pedal exerciser out of box, then handle it with care. Look at picture 1.
2. Lay out pedal exerciser on the ground in the same level, then put knob A on to it as picture
shows. Look at picture 2.
3. 3.Turn Knob A and make the resistance properly. Turn left will increase the resistance, turn
right will decrease the resistance. Press the counter (C) and you can rotate the handle (step).
Look at picture 3.
4. Pull the pin (D) after use and fold it if you need. Look at picture 4 & 5.
5. Note: (1) inspect it and make sure it is placed steadily and in same level before use.
(2)
Don’t forget to let the resistance be minimum when start to use, then increase it to reach what
it does need.
1
2
A
3
4
5
EXERCISE COMPUTER INSTRUCTION MANUAL
SPECIFICATIONS:
TIME -------------------------------- 00:00 ~ 99:59 MIN
COUNT ---------------------------- 0 ~ 9999
REPSMIN ------------------------- 0 ~ 9999
CALORIE ------------------------- 0 ~ 9999 KAL
KEY FUNCTION:
MODE: This is lets you to select and look on to a particular function you want, and hold the key
for 4 seconds to have all function values reset.
OPERATION PROCEDURES:
AUTO ON/OFF:
The system turns on when any key is pressed or when it sensor an input from
the speed sensor. The monitor will be automatically shut off if there is no any coming in 4
minutes.
FUNCTION:
Time:
By pressing the MODE key until the
‘
▶
’ points to TIME. When the speed sensor has any
signal input, it stars the count up and automatically accumulates workout time when starting
exercise.
COUNT:
When
‘
▶
’ points to COUNT, the computer will display the steps. When the speed
sensor has any signal input, it starts the count up and automatically accumulates workout
counts when starting exercise.
REPS/MIN:
By pressing the MODE key until the ‘
◀
’ points to REPS/MIN. When the speed
sensor has any signal input, it starts the count up and automatically accumulates workout
counts when starting exercise.
CALORIE:
By pressing the MODE key until the ‘
◀
’ points to CAL. When the speed sensor has
any signal input, it starts the count up and automatically accumulates workout calories when
starting exercise.
SCAN:
When
‘
▶
’ points to SCAN, the computer will automatically display of the following
functions in the order shown:
TIME ----- COUNT----- STRIDER ----- CALORIES
NOTE
1. If improper display on monitor, please re-install the battery.
2. BATTERY SPEC: 1.5V AG13 (1PC)
C
B
D
