Page
7
Assembly Instructions
Hardware Required
#59. Special Washer
[4 peices]
A s s e m b l y S t e p 3
Lower Handlebar Assembly:
The
two Spacers (#33)
and
Special Washers (#59)
are
already pre-assembled on the two bars that are protruding
from the
Front Post (#31)
.Ensure that they are properly
in place as indicated in the assembly below.Slide the
Left
Lower Handlebars (#29L)
with the longer end of the shaft
towards the center of the
Front Post (#31)
. Then secure it
with one
Big Washer (#37),
a
Spring Washer (#38)
and
a
Hex Bolt (#39).
Repeat this process on the other side.
Pedal Arm Assembly:
The
Plastic Spacer(#15)
and the
Special Washer (#59)
are already pre-assembled.Ensure that they are properly
in place as indicated in the assembly below.Slide the
Left
Pedal Arm (#11L)
into the Crank Stud and secure it with
one
Big Washer (#13)
and a
Nylon Nut (#14)
as shown
in the assembly below
.
Repeat this process on the
opposite side.
Before attaching the
Left Lower Handlebar (#29L)
to the
Left Pedal Arm (#11L),
remove the zip tie at the bottom of
the
Left Lower Handlebar (#29).
Then attach the
Left
Lower Handlebar (#29)
to the
Left Pedal Arm (#11)
and
secure it with a
Hex Bolt (#22),
a
Washer (#17)
and a
Nylon Nut (#16).
Repeat this process on the opposite side.
BR 2710
