BRT5128 BRT5118
Page 9
Assembly STEP 3
Remove Hex Bolts
(#21)
and Nylon Nuts
(#27)
that are
pre-assembled on the Pedal Connection Joint
(#08)
and set
them aside as they will be used in later in this step.
Align and attach the Pedal Connection Joint
(#08)
to the
right Crankshaft
(#40)
. Insert the Right Pedal Hinge Bolt
(#25)
through Pedal Connection Joint
(#08)
and Crankshaft.
Secure the Right Pedal Hinge Bolt
(#25)
with
a
Wavy Washer
(#59)
tightly into the
Crankshaft
(#40)
by turning
CLOCKWISE
.
Then, secure with one Spring Washer
(#32)
and a Right Nylon
Nut [w/white inner nylon ring]
(#30)
.
Attach the Pedal Connection Joint
(#08)
to the Right Pedal
Tube
(#39)
. Insert one Hex Bolt
(#21)
through the upper
bracket of the Pedal Connection Joint
(#08)
, followed by
Right Pedal Tube
(#39)
then the lower bracket of the Pedal
Connection Joint
(#08)
. Secure them with one
Nylon Nut
(#27)
.
Attach three Bolt Caps
(#34)
over three Bolts as illustrated
in the drawing.
Repeat the above process on the LEFT side of the machine
and turning the Left Pedal Hinge Bolt
(#26)
COUNTER-CLOCKWISE
.
Note :
Keep the Right/Left Pedal Hinge Bolt
(#25/26)
perfectly
straight as they go through the Pedal Connection Joint
(#08)
and the Crankshaft
(#40)
.
If the Right/Left Pedal Hinge Bolt
(#25/26)
are connected to
the Crankshaft (
#40)
incorrectly, damage to the Right/Left
Pedal Hinge Bolt
(#25/26)
and Crankshaft
(#40)
will occur.
Hardware Required
#26
Left Pedal Hinge Bolt
[1 piece]
#25
Right Pedal Hinge Bolt
[1 piece]
#21
Hex Bolt (M10x55 mm)
[2 pieces]
#32
Spring Washer
(1/2")
[2 pieces]
#29
Left Nylon Nut
(w/ black inner nylon ring)
[1 piece]
#30
Right Nylon Nut
(w/ white inner nylon ring)
[1 piece]
#27
Nylon Nut (M10)
[2 pieces]
#34
Bolt Cap (S17)
[6 pieces]
01
25
59
30
32
40
27
08
09R
34
34
39
21
34
59
25 59
2640
40
32 29
30 32
LEFT CRANK
RIGHT CRANK
counter-
clockwise
clockwise
#59
Wavy Washer
[2 pieces]
