8
STEP 6
Connect the pulse sensor wire to the Computer pulse
sensor wire.
Plug the Upper sensor wire (pt. C-1) into the computer
cable box at the back of the computer (pt. A), and slide
the computer (pt. A) down to the computer bracket
situated at the top of the Front post (pt. C). Then fix with
four M5*10 Screws (pt. A-1).
STEP 5
Attach the Handlebar (pt.B) to the Front
Post (pt.C) by using clamp (pt.H), fix
with one
φ8 Flat Washers (pt.H-3), one
φ8 Spring Washers (pt.H-5), one M7*30
Bolt (pt.H-1).Pass the pulse sensor wire
through the hole.
Fit the Rear handlebar cover (pt.C-2) to
the Front handlebar cover (pt.C-4) by
using one M5*14 Screw (pt.C-3).
STEP 7
Fix the Front handlebar cover (pt.C-4) to
the Front post (pt.C) by using one
M5*14 Screw (pt.C-3).
Connect the Front handlebar cover
(pt.C-4) to the Rear handlebar cover
(pt.C-2) by using two M4*40 screws
(pt.H-6).
Use one set of Bushing (pt.H-2),
φ8 Flat
Washers (pt.H-3) and
φ8 Spring
Washers (pt.H-5) to screw the T bar
(pt.H-4) onto the Front post (pt.C).
Please plug the adapter (pt. K) into the
socket situated in the rear of the chain
cover.
