18
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
and after STEP 3D. Some components may be pre-assembled. Nylon lock nuts will not
fully screw onto bolts, they must be wrench tighten to fully go on.
3A.
Attach Upper Handle Bar
(G)
to Right Lower Handle Bar
(L)
using:
1 - (#10) M6x12mm Button Head Cap Screw
1 - (#23) M6X22mm Barrel Nut
3B.
Attach Upper Handle Bar
(G)
and Right Lower Handle Bar
(L)
to the
Right Side of the Upright
(B)
using:
2 - (#4) M8x45mm Hex Head Bolt
4 - (#14) M8 Washer
2 - (#20) M8 Nylon Lock Nut
3C.
Attach Upper Handle Bar
(G)
to Left Lower Handle Bar
(F)
using:
1 - (#10) M6x12mm Button Head Cap Screw
1 - (#23) M6X22mm Barrel Nut
3D.
Attach Upper Handle Bar
(G)
and Left Lower Handle Bar
(F)
to the
Left Side of the Upright
(B)
using:
2 - (#4) M8x45mm Hex Head Bolt
4 - (#14) M8 Washer
2 - (#20) M8 Nylon Lock Nut
3E.
Attach Bungee Cords
(#28)
to Lower Handle Bars
(L & F)
and Pivot
Arms
(E)
.
3F.
Attach Safety Strap
(#36)
to Back Frame
(H)
.
NOTE:
Always make sure the Ankle Lock Mechanism securely locks the
ankles by TURNING the Knob
(#39)
COUNTERCLOCKWISE when in use.
