14
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3B. Some components may be
pre-assembled.
Option #1: Weight Horn Configuration
for Olympic Plates
3A.
Attach Uprights
(B & F)
to Base Frame
(A)
using:
4 - (#2) M10x75mm Hex Head Bolt
8 - (#4) M10 Flat Washer
4 - (#5) M10 Nylon Lock Nut
2 - (E) Steel Plate
3B.
Attach Two Crossmembers
(C)
to Uprights
(B & F)
using:
8 - (#1) M10x100mm Hex Head Bolt
16 - (#4) M10 Flat Washer
8 - (#5) M10 Nylon Lock Nut
4 - (E) Steel Plate
3C.
Insert Rubber Donuts
(#6)
onto Weight Horns
(D)
.
Summary of Contents for GWT76
