6
Step 4: Tighten all bolts and screws
Step 5: Handrail Cover Assembly
1. Place the Left inner handrail cover onto
the Left handrail and tighten this cover
with two M5 x12mm screws using Phil
-
lips screwdriver.
2. Now place the outer handrail cover
through the handrail and onto inner cov
-
er. Insert four more M5 x12mm screws.
Tighten all 6 screws now.
3. Repeat procedure 1 & 2 for the Right
handrail covers.
4. Place the handrail cover inserts into the
inner handrail covers.
Step 6: Motor Cover Assembly
1. Place the Left motor cover onto the left side of
frame.
2. Insert and tighten the self-tap M5 x 10mm
screw into the center and top mounting hole
using Phillips screwdriver.
3. Insert and tighten two M5 x16 on front and rear
end of the cover using Phillips screwdriver.
4. Repeat procedure 1, 2 & 3 for Right motor cov
-
er.
Step 7: Finish Up
1. Make sure the treadmill is leveled on the
floor. Use a level tool, and adjust it if nec
-
essary.
2. Plug your power cord in and turn ON the
treadmill.
3. Make sure your safety key is in place.
